Installation

Installation

CAM-CVR installs simply and easily using the same screws as the license plate and backup camera.  Simply remove the license plate screws and plate and set aside. Install grommet around wire and insert through slot into hole at the top of the slot. Align mounting holes of camera, license plate, and CAM-CVR and start screws. Adjust slack in wire, center CAM-CVR, backup camera, and license plate then tighten screws.

Rear Camera Guard _ 2. ASSEMBLY

 

Note: Installing the grommet may require cutting one side to slip wire into center.

Leave a Reply

Your email address will not be published. Required fields are marked *